|
#32
|
||||
|
||||
Quote:
i checked with cml on the use of shims as the chassis was bent at the rear. They confirmed it is as i have said above. if you measure the size of the bit that sits in the chassis hole it is 3mm. Therefore if you run less than a total of 3mm you end up with a gap between the blocks and box mounts. This causes the chassis to bend round the box bottom when screwed down. its not what works, its how its designed to be used. its the same as the 22 system, works exactly the same way keeping the box level and also at the same height.
__________________
Stephen Smith Answer RC Team HB Racing | Team Orion | Xpert | Racing Experience |
|
|