|
#1
|
|||
|
|||
Best spur replacement for DB-01?
Hi, Can anyone advise, which replacement spur gear is the best one of the options available I've done some searching and found a blue one : 3Racing 10 Derlin Spur Gear 91T For DB-01 as well as the standard tamiya one 91T.
Thanks for your help with this. |
#2
|
||||
|
||||
B4 B44 ones fit.... if you have the slipper unit?
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#3
|
|||
|
|||
yes, I have the slipper, and a B4, with a spare spur. I will need to check, but I think it's a 78 or 81 T, which is smaller.
Is the durability similar to the ones I mentioned above. I do you think? I know in my B4, it seems to be lasting forever |
#4
|
||||
|
||||
had no problems with tamiya one's on the 511, but the b4 and b44 both fit ok with slipper
|
#5
|
|||
|
|||
My durga seems to make alot of noise compared to what I'm used to with my B4, I noticed that a few of the teeth in the spur are damaged, like a stone has got in there and hacked them. Is this likely to be the source of the noise do you think?Any advice appreciated, before I try a new one in there.
|
#6
|
||||
|
||||
the Tamiya spur is noisy as a norm. RW make spurs that fit too!
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#7
|
||||
|
||||
I've had the same B4 spur in mine since I built it just after they were released and had no problems with it.
Yes they are a few teeth small but compensate with a smaller pinion and you'll be fine (there's enough room in the motor adjustment to allow for a smaller pinion and spur).
__________________
Dragon Paints |
|
|