|
||
|
 |
|
||||||||||||||||||
|
#1
22-09-2018
|
|||
|
|||
Running out of distance
Hi all new to this we have just fitted a new brushless motor in our absima car everything works apart from the distance do you have to tune anything in . Before the car would be at the end off the car park and you’d still be able to drive it not it s only getting 10/20 metres and stops till you walk towards it
Last edited by Rizla; 22-09-2018 at 04:12 PM. 
|
|
#2
22-09-2018
|
||||
|
||||
|
Possible damage to the end of the aerial on the receiver, should have about 1/2 inch of white end showing, I have had a similar issue when I used an etronix tx and rx and part of the little white end snapped off reduced the distance massively, worth checking???
__________________
Schumacher Cat L1 Evo Schumacher Cougar Laydown Schumacher Cat L1 Schumacher Cat K2 Schumacher KF2 Tamiya DF03 Dark Impact Tamiya TB04 Vintage Tamiya TL01 Baja Champ Vintage Tamiya Striker
|
|
#4
22-09-2018
|
||||
|
||||
|
I had an Absima CR4T Tx/Rx which did similar. I contacted Absima and thy were brilliant and replaced it. All sorted, but not sure what the problem was mind you
__________________
I've got Araldite and a Swiss Army Knife - what more do I need? Yokomo YZ-2 No 4WD because nothing lives up to my original Optima. Until now maybe?...
|
 |
|
|
Linear Mode
