Our go at a lipo X6

[ashleyb4]

Our go at a lipo x6...

Here are some pics of our attempt at a lipo x6 we filled the front battery slots with some apoxy putty up to the little brace bit and then filled the rear battery slots but still allowing room for lead. We also filled the spare screw holes for the 3 gear box and put screws to hold the wing instead of the clips. And finally sprayed his shell which is still drying. here are some pics.....







Ashley and Jono

[sebx6france]

DSC_0748.jpg

DSC_0749.jpg

[ashleyb4]

Bodyshell done nice and simple....




A

[Garry Driffill]

Looks rather cool

[ben]

Nice dremel work on the chassis

[ashleyb4]

It was unchartered ground was difficult to try and get it tidy. Jono dremmeled it i sanded it.

A

[jono83]

lol its not as bad as the photos make it look its all neat and tidy in the chassis, the wing mounts where easier than i thought they were gonna be to

[super__dan]

Looks good!

I'd move the rear camber link out though, ideally the E Speed hangers of course

Is that a receiver pack???

[Chequered Flag Racing]

Originally Posted by super__dan

Is that a receiver pack???

Look like the caps that come with the Speed Passion esc's

[ben]

Originally Posted by Chequered Flag Racing

Look like the caps that come with the Speed Passion esc's

Correct

[jono83]

Originally Posted by super__dan

Looks good!

I'd move the rear camber link out though, ideally the E Speed hangers of course

Is that a receiver pack???

on order

[shark]

Where did you get the putty from mate.

[jono83]

got from halfords its made by araldite its two part and you jus cut off what you want and mix in your hand be quick though as its rock jard in about 10mins

[ScottyP]

What slipper and spur gear set up is that?

[Garry Driffill]

Looks like an RW Racing spur with a B4 slipper set-up

[ashleyb4]

Losi spur and pads AE spring plates still tryhing to figure out how to fit the losi slipper.

A

[steel]

Originally Posted by shark

Where did you get the putty from mate.

Try milliput m8 in black its on flebay mold it into the slots smooth of with water and leave till morning it sets rock hard think its epoxy based

[shark]

Originally Posted by steel

Try milliput m8 in black its on flebay mold it into the slots smooth of with water and leave till morning it sets rock hard think its epoxy based

Sounds like the stuff to get cheers

[Northy]

Originally Posted by ashleyb4

Losi spur and pads AE spring plates still tryhing to figure out how to fit the losi slipper.

A

Er.... you just put it on Ash. The slipper plates have the same key to the layshaft, you just need the short spring for the hydradrive.

G

[super__dan]

Locating the spring is the only thing, you have to drill out either the small spring locator washer or the big load distributing spring locator thing. Defo need the short silver Hydra spring though.