|
#1
|
|||
|
|||
Anyone used Tamiya TA05 steering knuckles on an LRP Blast?
These steering knuckles seem to fit the Blast fine, but when I tighten the wheel up fully, it doesn't spin freely, if at all.
Anyone else had issues with these? |
#2
|
||||
|
||||
i cant say ive tryed tamiya steering hubs ive just got the standard ones from the blast and they are a bit of an issue from the rtr mine jump out of the screws from the bottom and my dads did the exact same thing on the same side and it had been over tightened at the factory. ive looked at the maverick ones from the strada look very similar i just dont know if there stronger than the blast ones
__________________
LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2 |
#3
|
|||
|
|||
Quote:
The TA05 ones are basically the same size and shape and seem to fit perfectly. The CVD spins freely in the hand, but when the wheel is on, nothing. |
#4
|
||||
|
||||
When you put a wheel on, and it stops spinning freely when you tighten it, it is either because the wheel hex is too deep (solved by using washers to space it out or a deeper hex hub, or even sand down the wheel hex), or the pressure causes the hex hub to bind.
There are a number of solutions for the latter - 1. Use locking wheel hexes - these stop the hex hubs being forced onto the wheel bearing. 2. Find a suitable crush tube - this stops the inner and outer bearings from being pushed together 3. Sand down the back of the hex hubs, so the slot for the axle pin is shallower. Note: These are generic fixes for the problem, I don't own a Blast!
__________________
Photos: Oople Invernational 2010 - Sodden Sunday Muchmore N. Irish GP 2010 (Touring cars) BADMCC 1/8th Nitro buggies Current cars: X6^2 | JC BJ4WE | TM E4 & E4JS | HPI E-Firestorm | Losi Crawler | + many F1s, super crawlers, scalers, drifters in the works... |
#5
|
|||
|
|||
Quote:
|
#6
|
||||
|
||||
i got the metal lrp hex very good and cheap compared to most metal hex and yes it was the left front ive got a feeling they are over tightened on the assembaly line just on that side i replaced it and just nipped up the screw in the new one and its perfect now no problems
__________________
LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2 |
#7
|
|||
|
|||
Quote:
I've been looking at getting some from Freeprawn. Looks like I'd better get my order in |
|
|