MRT PT No Signal, Very Weak Signal

[Cremegg]

Hi

Run an speed passion gt2.0 pro esc and alturn servo

Ive recently purchased a new mrt pt but the loop at our club is picking up a very weak signal, and it only picks it up if it is rubbed over the loop (0 mm off the ground)

My lvc was set to 3.4 and I was having trouble with my steering glitching at not getting full power (on and off this was happening),

I changed this setting to 3.0 and now the power and servo work flawlessley.

Unfortunately the loop was put away by the time I was able to test if the pt would now work better

Could this of been the reason why I was getting no signal from the pt? As not enough voltage was getting to the pt


Thanks

[Karting]

Do you know what software your club is running? If its rc4 that will explain why it dosnt work (as MRT is not compatable with RC4 software anymore)

[mark christopher]

You 100% sure its connected properly?

[Cremegg]

Hi mate

Yep they run amb rc3 which is compatable with the mrt's

About 5 guys run them at bury

Yep connected correct as solid blue light

Thanks

[Si Coe]

Chris - It can't be that or it would have worked in my car too. I tried it in mine alongside my identical MRT PT, mine worked but I got nothing from Chris's.

The only way we got a signal was having it dangling out the car on the ground.

[birdy]

Must be faulty, I'm sure MRT will replace it.

[Cremegg]

Originally Posted by Si Coe

Chris - It can't be that or it would have worked in my car too. I tried it in mine alongside my identical MRT PT, mine worked but I got nothing from Chris's.

The only way we got a signal was having it dangling out the car on the ground.

What do you think si

Shall I send it back or try it again on sunday after fixing my esc

Read up about it on the website and there saying it.might be because the bec wasnt giving enough voltage out

Ive emails mrt too to see what they say

Thanks