|
#1
|
|||
|
|||
Cat K1 Setups
Attached below is the setup i used at Silverstone Winter Series yesterday - high grip astro/carpet. I have found over testing that this is a good base starting setup and have been using at most places. The only changes I made yesterday was to go up 50wt all round.
Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC |
#2
|
||||
|
||||
silly comment sorry
|
#3
|
||||
|
||||
Is that using core rc oil si?
__________________
'There are two choices in life-Take it or leave it !' Yokomo - Nemoracing Sb Designs http://www.fairfueluk.com/ |
#4
|
|||
|
|||
Yeah Core Rc Oil
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC |
#5
|
|||
|
|||
Any chance of making this thread sticky? People are already commenting that we could do with a setup section. I will do my very best to put new setups up when i test/race etc and Im sure Tom, Grant, Danny & Llloyd will do the same where possible.
Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC |
#6
|
|||
|
|||
Kiddy Test Day & my starting setup for Worksop this Sunday
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC Last edited by Mossy; 02-01-2013 at 12:03 PM. Reason: Added Setup |
#7
|
||||
|
||||
Simon is that right on the setup sheet, that you use 1.2mm pistons in the rear and 1.3mm in the front, or is that an error on the sheet?
__________________
Xray, Orca, 1UP Racing, Avid, X Factory UK, RC Disco, Hudy, RichPaint, RDT products, Screwz4rc http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#8
|
||||
|
||||
white = 1.2
black = 1.3 red = 1.4
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#9
|
||||
|
||||
Mark thats not the question i was asking, and i was asking Simon.
__________________
Xray, Orca, 1UP Racing, Avid, X Factory UK, RC Disco, Hudy, RichPaint, RDT products, Screwz4rc http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#10
|
||||
|
||||
Quote:
on simons set up sheets are piston colours which tie to the sizes doubt simon would enter, the wrong piston colour and sizes down wrong
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#11
|
|||
|
|||
Preddy, yes that's right.
I also asked the question at Silverstone, Si runs smaller hole piston in the rear
__________________
http://insidelineracing.co.uk |
#12
|
||||
|
||||
Didn't work for me, then again we don't all have his thumbs!!
__________________
Absima - InsideLineRacing - Puppy Paint |
#13
|
|||
|
|||
@ Father Christmas
SNAP!!
__________________
http://insidelineracing.co.uk |
#14
|
|||
|
|||
Ignore
__________________
http://insidelineracing.co.uk |
#15
|
|||
|
|||
The setup sheet is correct to what I've been running. To be honest I have been messing around with pistons in the front and this just what I have settled on for the time being. I run the setup with the bigger pistons in the front as at Silverstone I wanted the back to be pretty damped but the front to dip into the corners at low speed.
At Worksop I might well change this a little as I will want more rear end. Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC |
#16
|
|||
|
|||
Attached is the setup i finished on at Worksop last week, my apologies for the delay. I made a lot of changes throughout the day and this is the setup i ran in the final. Was really pleased with the car in the final, nothing between me and Nath Waters (if any of you saw the final) and not massively slower than Neil. The car was far more balanced on the shock settings and handled the table tops etc much better. The majority of my changes were to generate low speed steering, hence the extra washers under the front inner ball stud. Ill be starting with this exact setup tomorrow at Broxtowe, so any comments/ discussions please feel free to ask.
Cheers Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC Last edited by Mossy; 12-01-2013 at 04:09 PM. Reason: Missing shock position on attachment |
#17
|
||||
|
||||
Si see ur running the option chassis, is this carbon or s1?
Also the rear blocks your running rear low frong high, what does this do?
__________________
'There are two choices in life-Take it or leave it !' Yokomo - Nemoracing Sb Designs http://www.fairfueluk.com/ |
#18
|
||||
|
||||
Quote:
simon also runs the alloy rear blocks and fine tunes with washers, which you can not get with the kit part. (sat next to him at worksop and asked the same)
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#19
|
||||
|
||||
Petitrc Race setup for clay.
So, this weekend was my debut with this beast, at the Petitrc race held at a cementhard clay track with varying grip, horribly executed jumps, and a reputation for killing any car you throw at it.
With the Schumacher in kit form, even though responsive and well jumping, this wasn't it's favourite playground. But I've only broken one suspension arm through a weekend of racing, and I now got a decent setup for clay I switched to the white piston up front, Losi 40 oil, TLR green springs(3.5) and 7.5 yokes. In the rear I had Losi 35 oil(felt heavier than kit), TLR yellow springs and a 1.3 mm Yokomo B-max roll bar, with a custom mount. I was testing a few oils and springs, but this is what turned out best so far. I didn't have time for testing any links, toe adjustments and such, and the car is still a bit on edge, but this setup made me have the A-main pace, even if I couldn't deliver. So far so good, I'm looking forward to more testing
__________________
Martin Sørlie, 1985. Spektrum DX4R Pro - TLR 22 2.0 & TLR 22-4 - Absima Team Smallsize |
#20
|
|||
|
|||
Had a couple of pm's asking for my setup from Worksop on Sunday so i will do my best to get it up when i'm back from work tonight. My car was fantastic, best I have had it so far so hopeful I might have found a better base setup.
Si
__________________
Schumacher, Hobby Wing, Thunder Power, Anderson, Sanwa, Trishbits, P-Dub Racing, Rudebits, Inside Line, Nuclear RC, RC Domination, RPC |
|
|