|
#1
|
|||
|
|||
Upgrade gtb slipper pads and lay shaft
Really dumb question but how do I fit this upgrade?! I've worked out that I don't need the left hand side pulley insert as its built into shaft but how do I fit the drive pin as the pulley covers the hole!
I'm running the alloy pulleys by the way. |
#2
|
|||
|
|||
You need to fit the pins mate both side.thay will fit just need to grind a couple mm off each pin
|
#3
|
||||
|
||||
Hi Chris
As said you do need to put the pin in first, if you are running the alloy pulley you need to just take a tiny bit off the end of the pin, about 0.25mm is all it needs |
#4
|
|||
|
|||
Thanks guys, I thought it was a bit tight!
|
#5
|
||||
|
||||
You can push it through the plastic pulley, only needs a tickle on the pin if you are using aluminium
|
#6
|
|||
|
|||
yes using the alloy pulleys so I taken a tiny bit off each end.
Cheers again |
Thread Tools | |
Display Modes | |
|
|