|
#1
|
||||
|
||||
db-01/502X front Hex
Anyone know where I can get some, I lost mine in the grass today.... and I think it got sucked into a parallel universe and vanished.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#2
|
||||
|
||||
Brockmodels have them
__________________
Hobao H2 Pro xbox/ps3/Wii U : budge1972 (add me) |
#3
|
||||
|
||||
top man!!
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#4
|
||||
|
||||
Budgio, you got a PM
Guys, Brock models, not being funny, their site is unsecure.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#6
|
||||
|
||||
I was looking at the B44 ones, and am tempted by them, as I could run the B44 front wheels then!!
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#7
|
||||
|
||||
But I run Tamiya wheels on my B44, or is it late and I'm too tired to get what you're saying?!!
|
#8
|
||||
|
||||
Has anyone run B44 front wheels with the normal, factory 501X front wheel hex? Do they fit ok? A friend gave me a set but I have not mounted tires to them.
__________________
Tamiya America - Trakpower - 92Zero Designs |
#9
|
||||
|
||||
the B44 wheels have a deeper hex, so when you tighten down the nut, they bind grr
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
#10
|
||||
|
||||
Sorry if I'm asking an obvious question, but how should I go about drilling some AE hexes? I need to increase the internal diameter from 4.7mm to 5.0mm to fit the DB01R axles. Is it just a case of holding it in a vice and using a regular 5mm bit?
|
#11
|
||||
|
||||
just fit the imperial drive pins with a bit of AW grease I would of thought.
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man! |
|
|