FOR SALE Vintage Motors, ESCs, Ultima chassis, Mardave Mini

[JustinWood]

Hi, here is my collection of motors from the 1980s and two Speedmaster Silverstar ESCs also from the 1980s

If collecting and restoring vintage motors is your thing then take a look!

I have not rebuilt or tested these motors, they are exactly as they were when I stored them about 25 years ago, however the first three motors I checked and they did run cleanly. Both ESCs do work.

If there is a particular motor you are interested in I can connect it to a power source to check it runs (however I do not have the kit to measure rpm or torque).

I am selling the motors as a job lot for £35 including postage, or £20 for 5 motors (first buyer can choose or otherwise I will randomly select). The ESCs are £10 including postage, one comes with the original instructions the other comes with a photocopy. Paypal gift or buyer pays fee.

Based on the markings on the labels or can the motors are as follows:

Demon 17x2, 18x4, 14x3

Demon Gold 14x2

Demon King 15x2, 14x4

Reedy (unknown turn)

Parma (unknown turn, guess is somewhere between 15 and 19 turn, as this was my favourite at the time). Sticker indicates motor was rebuilt by MG back in the day

Twister 15x2. Sticker indicates motor was rebuilt by MB back in the day

Twister 19x4

[JustinWood]

Hi, here are my Schumacher chargers from the 1980s. Amazingly both still work, one comes with the original instructions the other comes with the original box. Both were used regularly back in the day but are in good condition. They are both peak and temperature chargers which we used for charging NiCds. They are £15 each including postage. Paypal gift or buyer pays fees. Please let me know which one want when you contact me.

[JustinWood]

SOLD

Hi, here is my Mardave Mini Stock MkII from the 1980s. This is a well used car as you can see, raced outdoors in a car park and indoors on carpet. The car is complete but is very dirty and the tyres deteriorated, and so the buyer would need to disassemble and clean, although these are not complex cars to do so. The body is sprayed on the outside so the buyer can change the look. Comes with the original instructions for £25 including postage, paypal gift or buyer pays fees. The electronics shown are also from the 1980s and included but untested. No batteries or RC is included.

[JustinWood]

Hi, here is a well used chassis for the Kyosho Ultima, which I have discovered clearing out my garage.

This is the aluminium chassis with graphite plate, which I believe is for the Ultima Pro (3117) model.

Note, this chassis is shorter than the Ultima Pro (3119) aka Pro XL, I know this because I raced a 3119 car back in the 1980s and the 3119 car had a graphite chassis. At the time, I kept the aluminium chassis as a spare, convinced that the graphite one would break (it never did).

For avoidance of doubt the chassis I am selling is 28.5cm long on the flat section and a further 4cm on the angled section. Its £25 including postage, paypal gift or buyer pays fees.