|
#1
|
|||
|
|||
Mardave Tyres & Pinons
HI,
please can you let em know what the best contact tyres are for the mardave, I am looking at the 48dp pinions on modelsport do I need the micro or long boss ones? thanks Trev |
#2
|
||||
|
||||
Hey Trev,
you need hard on the front and soft on the rear. A good combination would be 50sh up front and 35sh at the rear. I have a set like this but have not yet run them. My current setup uses Jap 52sh up front and Mardave pink mediums at the rear, but I think the Contact tyres will be even better than this. For pinions you only need a standard boss. Long boss isn't necessary. The bore must be standard (1/8"), not 3/32" (2.35mm) as this will not fit on the shaft of a 540 size motor. DAVE |
#3
|
||||
|
||||
Yes, the 50 fronts and 35 rears are what you want. Be careful of the front suffix. Fb is for the front bearing wheel and anything else well isn't . It does explain it on the Dave site
|
#4
|
|||
|
|||
Thanks for the Info, new Tyres and Pinions ordered
|
|
|