|
#1
|
||||
|
||||
sensor lead problem
i have a 120amp xcar esc and a speed passsion motor.if i use the sensor lead then it misses on 2 phases.but if i disconect the lead then it does not and runs on all 3 phases.i have tried 3 good known leads and all the same.also tried it on 3 known motors and the same thing.
__________________
Current rides N slides and flies sponsored by http://www.westernvalleymodels.co.uk/
|
#2
|
|||
|
|||
There's only one suspect left, the esc.
|
#3
|
||||
|
||||
No sense!
Is it possible the motor sensor board is damaged?
They are a replacement item in most motors and are liable to sensors breaking down especially after large impacts! |
#4
|
|||
|
|||
That's the first thing I thought. Then I read his post again, he has tried three different motor's with the same result.
|
|
|