|
#1
|
||||
|
||||
Basic engine tuning for noobs
Two guys I work with have both bought second-hand Traxxas T-Max trucks, both in good nick but they can't seem to set them up properly. They've followed the instructions on the Traxxas website for basic set-up which consists of screwing the high speed needle all the way in (full lean) then 4 turns out as a 'base' mixture then setting the low speed screw flush with its housing and finally the idle as low as possible. The problem is neither car will run for more than 5 minutes without stalling. Now from what I can gather from the website and of Youtube, a too-lean mixture will cause stalling, yes? All I'm after is some pointers (my advice is to go brushless ). Thanks in advance.
|
#2
|
||||
|
||||
If they are running on base settings, they wont get more run time than 5 mins.
|
#3
|
|||
|
|||
I seem to remember having a shed load of problems with my TRX3.3 when I had a TMaxx.
Sounds like its probably a little rich still, certainly if its still on the stock settings it will be. You'll want to tweak the bottom end a bit first, then the idle then the top end. Little vid might help
__________________
|
|
|