WANTED KC => L1 rear conversion

[breizhator2]

Hi i'm looking for L1 rear conversion set for Schumacher KC Regards

[knighthawk]

You can get the parts to convert

U7613 CVD LD Driveshaft
U7493 Hex 7.5 L1
U7333 Wishbones
U7368 Outboard Pivit Pin L1
U7392 Rear Hub L1
U2698 Hub Bearing

[mark christopher]

Originally Posted by knighthawk

You can get the parts to convert

U7613 CVD LD Driveshaft
U7493 Hex 7.5 L1
U7333 Wishbones
U7368 Outboard Pivit Pin L1
U7392 Rear Hub L1
U2698 Hub Bearing

rear hub bearings are the same between kc and ld

[knighthawk]

Originally Posted by mark christopher

rear hub bearings are the same between kc and ld

Cheers Mark,

To be honest I stole the list from another thread
Not owning the conversion myself ( I missed out before they became discontinued )

I was going to get the bits, now know don’t need the bearings 🤪

[Kevg57]

the list depends on the age of the KC.

I had a kit from early this year and it had the L1 hubs and L1 length driveshafts, 67.13mm if I remember correctly.

if you run a roll bar you will need the L1 joints for the lower link to wishbone as it moves from outside the arm to inside the arm.

I did not change my hexes as the original kit did not have them in it, you do need an oring as a shaock bump stop though

original kit had
driveshafts
hubs
arms
orings
c clips spacers

[tyreman]

The conversion kit had Cat SX rear driveshafts in it, you can use the lay down driveshafts but you would need to get the L1 1.5mm hexes.