|
#1
|
||||
|
||||
Spektrum DX3S question
Hi,
So I have a Spektrum DX3S and I can't There is a problem with the travelsettings I want to lower this because if I brake, it's just like you handbrake the car. And I run a B4.1 so it's pretty sensitive if I brake, it just flips around.. If I change this, to lower then 100% then the car just drives forward Thanks
__________________
|
#2
|
||||
|
||||
Ive had this sort off problem before mate.
What speedo do you have ?
__________________
|
#3
|
||||
|
||||
I have a LRP SXX Stock Spec v2 with the LRP X12 17.5motor.
__________________
|
#4
|
||||
|
||||
ive had that speedo too
look at the manual at the setting up process and reset the throttle, neutrul and brake setting and that should help. before when i braked the brake was far to sharp and it would just spin out. Once you have reset it just lower the brake % and it makes it less sharp and increase it for more brake.
__________________
|
#5
|
||||
|
||||
oke so 3sec on set button neutral press set, full throtle again set and brake again set and it should be ok?
__________________
|
#6
|
||||
|
||||
i just resetted it and i still have the problem when i turn the travel of the braking lower then 70% the motor spins...
hmm
__________________
|
#7
|
||||
|
||||
__________________
|
#8
|
||||
|
||||
Thats strange
One my tranny my setting for brake is at 3% but then thats how i set it at and its strong enough. Have you got it set at these settings ? Description other names in radio Required Setting Throttle Travel High ATV, EPA 100% Brake Travel Low ATV, EPA, ATL 100% Throttle Exponential EXP, EXPO start with 0 Neutral Trim SUB Trim centre Servo Reverse Throttle Reverse any setting, don‘t change after set-up procedure!
__________________
|
#9
|
|||
|
|||
adjust the brake on the esc not the hand set if u can
|
#10
|
||||
|
||||
When I had that problem o didn't have to do that all I did was reset it on the handset and reset the throttle brake and neutral and it all worked
__________________
|
#11
|
||||
|
||||
Reset the model on the handset for your B4.1 model. This will change the name, but will remove any odd settings like weird throttle curves or anything else like that.
Once you have done that, go through the speedo setup again. Once complete, if the car still emits this behaviour, you can do the following: 1) Turn down the braking effect/travel/strength on the speedo - those speedos have very strong brakes, and are known for their power. See if there is a 75% or 50% setting for the brakes. 2) Then fine tune the brake travel/EPA on the handset to fine tune during a race. Hope this helps. Mark
__________________
:: AE B5MCE - SP 7.5 v3.0 Brushless Motor - Reedy Shorty Lipo - Savox Servo - Spektrum Rx :: :: Paint By Turnip Paint :: |
#12
|
||||
|
||||
Thanks for the responds guys.
I'll give it a try tomorrow. I just ran the car now with braking on level 4
__________________
|
#13
|
||||
|
||||
Hi,
So I tried this now for like 3-4 times but still nothing... I tried to reset the esc to it's default settings, still nothing... I'm really getting frustrated
__________________
|
|
|