|
#1
|
||||
|
||||
Losi XXX BK2 axles!!
hi,
any1 have any BK2 rear axles i can buy?? or know where i can get some?? ive tried all the model shops i can think of, nd not one of them has them. thanks in advance |
#2
|
|||
|
|||
if you mean the ally bits that go through the hubs i think i have a pair in the shop, drop me an email in the morning and i will check.
john
__________________
www.theraceplace.co.uk |
#3
|
||||
|
||||
bump!
|
#4
|
||||
|
||||
bump agen, these are kinda urgent...does any1 hav any??
cheers |
#5
|
|||
|
|||
Which specific part are you after??
The front axle? The rear axle for dogbones? The rear axle for CVD's or a.n.other part entirely.. |
#6
|
||||
|
||||
He’s after BK2 CVD outer axles i.e. that go from the bone through the bearings that the wheels then mount onto so he can do the X6 droop mod.
Andy, don’t forget you need the spacers too, I think they are the xx4 front bearings spacers though it says in Chris article on 2wdrc.com, might also have part numbers which are best to quote. You also need a CVD shim set ideally if you’ve lost the ones already on there |
#7
|
|||
|
|||
Nice one Dan.... I didn't spot the word "Rear" in the first post.
Is this to get more droop, like we used to do on the XXX4?? Andy.. I'll have a look in my spares box when I get back tonight. |
#8
|
||||
|
||||
I think I might have some kicking around ill have a look later
__________________
WWW.SERVOSHOP.CO.UK |
#9
|
||||
|
||||
Mat, I think the part # you need is 9968 CVD rear axle, Gen II.
How helpful am I? Phil, It’s essentially like that yes, with the stock B4 driveshafts and slight change to rear geometry on the X6 you can’t get quite the same rear droop as a B4 as the driveshafts come out of the outdrives (stock I used to run 2 more internal limiters than my B4 to stop this problem). After testing Ellis found that the car benefited from some extra droop, so to do this we use the CVD outer axles and B4 driveshafts to get as much droop as you would ever want |
#10
|
||||
|
||||
extremely! thanks dan
thanks for yor replys evry1, and i do have some large spacers dan, what length do they need to be? it said on 2wdrc i need 3/32" spacers, is this correct?? cheers |
#11
|
||||
|
||||
If that's what it says then that must be right as I used the same guide
|
#12
|
||||
|
||||
Do you want the CVD or the standard losi dogbone version of the axle, as I have 3 sets of each
__________________
TLR, Screwz4RC, Spektrum, Horizon Hobby, Trinity, Trishbits, Racer, RichPaint, RDT products, Sanwa, Zen Racing, Silverback Lipo's http://www.screwz4rc.co.uk My Trader Feedback - http://www.oople.com/forums/showthre...hlight=tyreman
|
#13
|
||||
|
||||
cvd version plzz
how much do you want for a set?? thanks alot |
#14
|
||||
|
||||
all sorted now, ive finally found some
cheers |
|
|