|
#1
|
||||
|
||||
Centre diff into ZX6?
Any one able to confirm what parts I need to put the 6.6 centre diff into the zx6?I can see the centre diff kit and centre mount kit are needed and 2x new centre shafts.but what else? as if it start to mount up I'll not bother.
__________________
Dave www.norfolkbuggyclub.moonfruit.com kyosho optima,Bosscat,Boomerang,,RB5 Vega,RB7,,RC12 5.2, TLR22-4,MP9,HB807T Flask of tea & a rollup Anglia model centre & CT Models http://www.oople.com/forums/showthread.php?t=28117 |
#2
|
||||
|
||||
So I'm guessing no one has bought a 6.6......wouldn't surprise me at closing in on 600 quid
May give a diff a go at some point
__________________
Dave www.norfolkbuggyclub.moonfruit.com kyosho optima,Bosscat,Boomerang,,RB5 Vega,RB7,,RC12 5.2, TLR22-4,MP9,HB807T Flask of tea & a rollup Anglia model centre & CT Models http://www.oople.com/forums/showthread.php?t=28117 |
#3
|
||||
|
||||
just diff and shafts unless your on the hd chassis you can dremel the mount a little i believe
__________________
YZ2 sanwa hi-tec Balls out zx6 Futaba orion sanwa Need a liner resized ? Liars run for cover the truth is taking over!!! |
#4
|
||||
|
||||
As bigT suggests.
No need for the new top cap, it is just a slightly machined version and you can easily dremel the kit one to clear (obvious where it rubs when you fit it). Drive shafts depend on chassis configuration as per the manual. I run my motor mount forward 100% of the time, some people shift forward and back so up to you really. Be GENTLE when you build the diff .... just GENTLY nip the screws down .... NO POWER DRIVERS!!!!! Make sure there is no vertical movement as you would the slipper, use grub screws in the holes over the bearings if you have any vertical movement and only GENTLY nip them down. I run 500k in the diff in damp-full wet, as soon as it dries I'm back on the slipper. Hope that helps a little. |
|
|