|
#1
|
||||
|
||||
SX3 lipo tray dimensions
Could someone please let me know the outside width of a single lipo saddle tray ?
Need to check if they fit before i purchase Cheers John
__________________
Used cars 1x CAT XLS, 3x Procat, 2x Cougar, 1x Bosscat New builds 1x Procat (Fibre-Lyte chassis), 1x Shotgun Runners Supastox, Tamiya TA03F |
#2
|
||||
|
||||
Are 1s lipos the same width as saddles at about 46/47 mm. I don,t have saddles yet but do have 1s ?
Need the width of the holder to make sure it will fit on the chassis and allow the Bosscat bodyshell to fit Hoping someone can help Cheers
__________________
Used cars 1x CAT XLS, 3x Procat, 2x Cougar, 1x Bosscat New builds 1x Procat (Fibre-Lyte chassis), 1x Shotgun Runners Supastox, Tamiya TA03F |
#3
|
||||
|
||||
I've used a SV2 lipo tray on my ProCAT and as you can see it fits easily within the width of the original chassis. SX3 trays are a little wider but not much, should still fit fine.
Hope that helps.
__________________
|
#4
|
||||
|
||||
Thanks for the reply. The problem I have is the belt is above the lower chassis on the Bosscat not like the Procat. My plan is to cut the lipo holder in half & hope is does not touch the lower belt cover.
Cheers
__________________
Used cars 1x CAT XLS, 3x Procat, 2x Cougar, 1x Bosscat New builds 1x Procat (Fibre-Lyte chassis), 1x Shotgun Runners Supastox, Tamiya TA03F |
#5
|
||||
|
||||
I still think you will have plenty of room for saddle lipos on the Bosscat chassis.
See pic |
Thread Tools | |
Display Modes | |
|
|