|
#1
|
|||
|
|||
501 bearings
can anybody tell me where you get be1 x2 , 1510 ball bearings from, i have tried brock models and rc- mushroom cant seem to find any thanks.
|
#2
|
||||
|
||||
1510 is a 10mm ID x 15mm OD bearing, not an unusual size, try searching your favourite shops again with those terms. You may not easily find Tamiya's own bearings as a spare but there are plenty of generic bearings around that will cost you about £1 each and they are absolutely fine.
|
#3
|
|||
|
|||
thanks
thanks
|
#4
|
|||
|
|||
Hi,
http://cgi.ebay.co.uk/10x15-x4mm-Met...QQcmdZViewItem i have used this ebay store a number of times. I have had no problems. Cheap and they do ceramic, i have always bought the grade5 bearings and found them to be a good product. Cheers Ollie |
#5
|
||||
|
||||
I get all My bearings from here
http://www.avidrc.com/shop/?action=payment Here is a list of all the ones you need. 5x9x3mm (3 pcs) 4x8x3mm (2 pcs) 10x15x4mm (4 pcs) 5x8x2.5mm (8 pcs) 3x7x3mm (2 pcs) 5x10x4mm (8 pcs) or you could get these but I 'm not sure if they are reliable... http://cgi.befr.ebay.be/3racing-Ball...sid=p1638.m122
__________________
...THE UNTOUCHABLES... |
#6
|
||||
|
||||
Andy,
I temd to swap mine with each rebuild, and alsways use tamiya bits, if your stuck I am sure I can dig out a couple of used sets? Also, try emailing rainbowten for parts availability, they nearly always have everything! The only thing to take care of is that most tamiya replacement bearing I have bought have blue plastice side covers, not the usual rings, if any of that makes sense!? Dave |
Thread Tools | |
Display Modes | |
|
|