|
#1
|
||||
|
||||
B44.3
Just built my New 44.3 and the rear diff has a tight spot, Ive heard on ae wheelers on facebook that associated in the states were replacing ring gear as the first kits had a dodgey batch supplied, has anybody come accross the same problem here?
|
#2
|
|||
|
|||
Have you ran it yet to see if it goes ?
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
#3
|
||||
|
||||
No not yet I was worried as it is fine and then there is a tight spot
Last edited by alan p; 05-04-2015 at 06:13 PM. |
#4
|
|||
|
|||
Just run on a setup table with no wheels on and slightly bed it in (aslong as you have built it right obviously)
Should be fine
__________________
Gareth Hill Schumacher - Sanwa - LRP - Mb models |
Thread Tools | |
Display Modes | |
|
|