D4 Cyclone Front Axle and Hub to TRF 501x (fix)

[SiR_Dave]

Hey Guys ....
I don't know if this has been done before but I found a few items of use from the Cyclone D4 that are very handy for the THIN front hex hubs.. that either tend to chew the crap out of the front wheels or crack if you over tighten them.. The D4 parts have a much better clamping area to hold the wheel to...plus the roll pin that comes with the hub set does not fall out all the time
You will need the following parts
61499 - Cyclone D4 front Wheel Hub Set for Losi wheels.
61470 - Cylone D4 front Axle shaft set.

[jimmy]

I've been using the hexes for a long time - but they do need drilling out to fit the Tamiya axles. I didn't know the hb axles could fit the tamiya bones - nice tip!

[sosidge]

Has anyone every tried running the 12mm hex HB wheels on a 501/Durga?