Fwd/reverse trouble RS pro

[Durango_Crazy_Mango]

Hi guys,

Almost at the end of my DEX410 build and I've ran into a slight problem.

I'm using the Dx3s radio and RS pro censored brushless system. The problem I have is when i first hooked it up i had to switch forward and reverse because it was backwards. After doing so forward now is noticeably slower than reverse. Can someone please help.

[Timee80]

now that youve switched forward/ reverse you need to re calibrate the speedo to the esc again like when you first set it up.

[Durango_Crazy_Mango]

Tried that also, so switched to rev on handset, start calibration on rs pro, hold for 3 secs, then go full throttle but it doesnt register it, doing my head in

[Durango_Crazy_Mango]

Its like the Tekin system is setup to go the opposite way the durango is made?? if that makes sense..

[Durango_Crazy_Mango]

Also, the LED's on the esc come from right-left under throttle, which is the opposite in the manual, which says throttle should be from left-right.

Also some have suggested swapping motor wires??

please help.

[K-Brewer]

Originally Posted by Durango_Crazy_Mango

Also, the LED's on the esc come from right-left under throttle, which is the opposite in the manual, which says throttle should be from left-right.

Also some have suggested swapping motor wires??

please help.

someone correct me if im wrong but swapping wires is for unsensored motors i thought but it does do the trick on unsensored

[adamjimny]

switch it on controller and set up using radio calibration. if motor spins in wrong direction just change motor direction in pit tune or on pc. motor wires must go A-A B-B C-C on a sensored system

[Durango_Crazy_Mango]

Damn i dont have link software for my rs pro.. looks like another 2 wks before driving this thing. Dont know why others havnt had the same problem on dex410's running the same esc.

Read also you couldnt swap wires on a sensored system.

This has really got to me, argh!

[paulj]

Just a thought here I don't know the 410 well as I'm strictly a 2wd runner now but you have got the diffs fitted the correct way around? The 410 is shaft drive I presume and if you have the diffs the opposite way to the the instructions on shaft drive it will go in reverse.

[adamjimny]

is there not a way to do it with the pit tune? on the speedo.....been a while since i had too. ill have a look now

[AfroP]

Originally Posted by paulj

Just a thought here I don't know the 410 well as I'm strictly a 2wd runner now but you have got the diffs fitted the correct way around? The 410 is shaft drive I presume and if you have the diffs the opposite way to the the instructions on shaft drive it will go in reverse.

This

Its a common mistake nearly every new 410 owner makes

[Durango_Crazy_Mango]

Haha wouldnt that be funny, i'll check but i think there is only one way around.

[mattr]

Originally Posted by Durango_Crazy_Mango

Haha wouldnt that be funny, i'll check but i think there is only one way around.

No. They fit in both ways round. You need the heads of the bolts down

[Durango_Crazy_Mango]

Hahaha YES! you have made my day

Thanks to everyone who helped! Owe you's a beer when in Western Australia.

Just took it for a lap, stoked.