|
||
|
 |
|
||||||||||||||||||
|
#1
11-11-2013
|
||||
|
||||
YR V2 Shorty 2wd 410
Just a few pics of the latest Yeldnips Racing 2wd 410 the YR V2.Shorty pack conversion.Sorry about the crap pics,crap camera phone.
     
__________________
Corally SBX410 Associated B6d Tamiya M05 Tamiya M06 low rider pumpkin TLR 1.0,3.0 scte Yeldnips racing products Xfactoryuk Dms racing Corally uk Last edited by spindles69; 11-11-2013 at 09:36 PM. Reason: added info. 
|
|
#2
24-11-2013
|
|||
|
|||
|
Excellent job! How does it drive?
Few questions: How did you go about achieving the proper rear kick up? I've thought about doing something similar with CF instead, but i'm puzzled with what to do about the rear kick. Did you make that rear brace or is the stock one wide enough to make this work?
|
|
#3
24-11-2013
|
||||
|
||||
|
YR V2
Hello mate,
Have only run car 3 times, twice indoors and today outdoors at HNMCC. Playing with the set ups at the moment,but on the time i have had with the car so far it looks promising. With the kick up,its the same as the 410.Do not know whether you could do it with c/f. With the rear brace,because i wanted to lower the angle of the center driveshaft all i did was use two rear braces cut down to get the width.So where the gearbox holder usually sits on the brace there is a gap so its sits the thickness of the brace lower to get a straighter angle out of the rear gearbox. Will post up more about the car as soon as i get it.
__________________
Corally SBX410 Associated B6d Tamiya M05 Tamiya M06 low rider pumpkin TLR 1.0,3.0 scte Yeldnips racing products Xfactoryuk Dms racing Corally uk Last edited by spindles69; 24-11-2013 at 06:04 PM. Reason: added info
|
 |
|
|
Linear Mode
