|
#1
|
||||
|
||||
Can Anyone Help Me Please lol
I am in bad need of the following to get My AE RC8B up and running:
Clutch Shim: http://www.teamassociated.com/parts/details/89137/ M3 x 8mm SHC Screw: http://www.teamassociated.com/parts/details/89223/ Clutch Bell Shim Set: http://www.teamassociated.com/parts/details/89148/ Please PM me if you have any of these |
#2
|
|||
|
|||
Ebay for the clutch shoe shimms dude
http://www.ebay.co.uk/itm/3204823645...ht_1361wt_1139 as for the screws and shims i dont think its too clinical to use the exact screws and any washers/shims that fit over the end of the nose cone but that are not bigger than the overal size of the bearing
__________________
LOSI SCT, Savox, InTech BR5 EVO, Ab Argus 52 www.bedworthRC.com www.cmcc-online.com www.ardentracing.com www.jcracingproducts.co.uk My Trader Feedback http://www.oople.com/forums/showthread.php?t=46608 |
#3
|
||||
|
||||
Am I right in thinking then, That all you do is shim out the bell until it is flush with the end of the shaft?
|
#4
|
||||
|
||||
no cause some times u have to put shims on the out side aswell, but shim it so it does'nt rub on the flywheel but so u have about 0.5mm end float.
|
|
|