|
#1
|
|||
|
|||
Any ideas what these parts are
I believe they are all schumacher, i think the top set of parts of bearing housings, but not sure what the smaller parts are, they seem to be all off the same tree, any ideas on the car they are for?
I've no idea what the other 2 sets are. |
#2
|
||||
|
||||
No idea what the parts are in the bottom photo - not from a car I'm familiar with.
The middle photo shows TopCat front suspension parts & steering drag-link The top photo, as you point out has Bearing housings for all earlier Schumacher cars with belt drive (Although the eccentrics only work with pre-BossCat/Cougar2 cars) The levers are CAT/ProCAT (they hang off the u/side of the top deck) ;-) Not sure what the circular thing is - at first I though it was a diff half, but it doesn't have the castlated connection to which the driveshafts would locate?
__________________
TeamC TM2 (V1) Xray T4 15' (I finally conformed!) Associated R5.1 1/12th Pan Car (Occasional Racer) + too many vintage racers to list! |
#3
|
|||
|
|||
thanks Dan, the bottom set look like some kind of gearbox housing, but are surprisingly small
|
#4
|
|||
|
|||
Hey Daz as dan has already said the top picture is steering levers from a cat-procat.
the small round part looks to be an end cap part of a 4wd layshaft pulley, the eccentric's could be either early cat- cougar or could be bosscat as they also came with black eccentric's for the pro diff. The last picture looks like it maybe from 1 of there nitro 2wd cars but not 100% sure |
#5
|
||||
|
||||
Bottom picture is a lazer zx gearbox casing but is missing the main biggest bit
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS |
#6
|
|||
|
|||
Is this going to be regular slot?
__________________
Schumacher CAT 2000 ec Fireblade EVO |
#7
|
|||
|
|||
|
#8
|
|||
|
|||
Yeah bottom pic is rear Kyosho lazer gearbox
|
|
|