|
#1
|
||||
|
||||
ball diffs which way round
i bought a used zx6 built and raced it yesterday. i think that the ball diff are in the wrong way. if u look from the front of the car the front diff spur gear was on the left and the same for the rear looking from behind was also to the left.yet in the manual there is something contradictive.one diagram clear states to put the front one spur to the right.yet the next page it says to put it to the left.but the manual also says front motor not diff so is this a typo on 2 accounts.
__________________
Current rides N slides and flies sponsored by http://www.westernvalleymodels.co.uk/
|
#2
|
||||
|
||||
Quote:
looking at the car from the front to the back front diff crown wheel on the right (A) front motor diff crown wheel on the left (B) rear motor rear diff crown wheel on the left (A) front motor diff crown wheel on the right (B) rear motor i run mine motor at the rear, shorty, servo sideways on the left , esc on the right ive a look on sunday at the WRCA ive also got a set of gear diffs for sale brand new if you need them Last edited by leeboy44; 20-04-2015 at 08:29 PM. |
#3
|
||||
|
||||
hi lee i think thats cleared a few things up. but why switch the diffs around? see u sunday
__________________
Current rides N slides and flies sponsored by http://www.westernvalleymodels.co.uk/
|
#4
|
||||
|
||||
You only switch the diffs if you want to move the motor front or rear, if you move the motor and not the diffs on the start line you will go backwards lol
|
|
|