Best countersunk screws

[mikeyscott]

After some decent 2mm countersunk screws.

Had some Swiss cheese ones recently, so recommendations?

[badger5]

Try www.modelfixings.co.uk you need to get the high tensile steel ones as they should be grade 10.9 or 12.9 which is high tensile. Stay clear of stainless steel as they are too soft, A2 is equivalent to approx grade 4 and A4 same as 8.8.

[shanks]

http://www.rc-screws.co.uk/

[Skye]

I bought a load of different sizes from Kev at Inside Line. I think they are only stainless steel, but touch wood I have never had any problems with them.

[U1timate PigDog]

Xray screw are really good quality but the price really shows, I'm not sure if they still do but they used to sell them in packs available from teamxray.co.uk.

I'm sure there are plenty of other good ones out there too, but generally speaking you will get what you pay for.

good luck

[PaulUpton]

Originally Posted by Skye

I bought a load of different sizes from Kev at Inside Line. I think they are only stainless steel, but touch wood I have never had any problems with them.

+1 never had a problem with mine

[johnnyp]

http://shop.cpdracing.co.uk/index.ph...ort=20a&page=3
High tensile screws!!

[markwilliamson2001]

Can recommend model fixings....all screws about 2mm will be a bit bendy though, or they just snap!

[mark christopher]

you wanting m3 screws with a 2mm hex or m2 screws which will be smaller hex

[mikeyscott]

M3 2mm

[mark christopher]

Originally Posted by mikeyscott

M3 2mm

i went to my local bolt suppliers bapp bolts, got shit loads for £20 of all lengths

[RoyBoy]

Originally Posted by mikeyscott

After some decent 2mm countersunk screws.

Had some Swiss cheese ones recently, so recommendations?

www.screwz4rc.co.uk highly recommended.

[Neil Skull]

You wont have a problem with Kyosho ones

[MHeadling]

+ 1 on Kyosho bolts, bought a few packs of these in my time, very good quality

[mikeyscott]

Many thanks people, have now ordered what I'm after along with some new hex ends

+1 for Kyosho