Mardave Adjustable ride height Alloy Pod

[Chequered Flag Racing]

it's here

http://www.mardave.co.uk/vrxspares/v...alloy-pod.html

[DCM]

This is making my 'ideal' Mardave even more expensive!!!

[alteredoggy]

just seen one in the flesh
very nice it is too

[Conrad]

Originally Posted by DCM

This is making my 'ideal' Mardave even more expensive!!!

1/12th is a cheaper option at least for having a car ready to run than a fully spec'd mardave now. :0

[Karl Dransfield]

Originally Posted by Conrad

1/12th is a cheaper option at least for having a car ready to run than a fully spec'd mardave now. :0

Tyres?

[Chequered Flag Racing]

Originally Posted by Conrad

1/12th is a cheaper option at least for having a car ready to run than a fully spec'd mardave now. :0

see what you mean

VRXce £90
Alloy Motor Pod £43
Carbon Chassis Kit £30

= £163

[DCM]

But a Mardave is more robust and cheaper to repair?

[Luke123]

Originally Posted by Karl Dransfield

Tyres?

Agree with Karl 12th tyres are a lot more money than madaves, plus shells are cheaper and spares

[cr1tch]

we have these on order !!!!! to go on my new CE car.

[Conrad]

Yes tires for 1/12th are alot more but I was just talking about the cost of the car by comparison.

[cr1tch]

Just got mine today

[cr1tch]

Hi Guys,

Just got these over the last week, once these was built up and installed into the car found that the rear axle would not turn we had to take off some of the Alloy on the pod just on the inside where the ride height inserts go!!! As the width of the whole assebelly seem just a tad to wide, Also had to shave off some of metal on the motor mounting holes as well as you cant seem to adjust the motor the get the correct mesh as the screws seems to bind when tightening them up!!

Any one else had issues????

Dan.

[Paulnuneaton]

I have one of these pods nice bit of kit again like yourself the problem i to had was the motor adjustment bottom hole just a quick dremmell and all was good shaved a little bit off the Z drive all good raced with it friday at ardent well impressed nice bit of kit well done Chris

[Wynney]

I've had the same issues with the gear mesh holes on plastic pods.

[Chequered Flag Racing]

quote from Team Mardave on FB

Team Mardave Hi All Just noticed a little issue,, As we made the Z drive part to take out slop in rear axle this makes the new pod spacing about 1mm to wide.. So easy fix is to reduce overall lengh of Alloy Z Drive or plastic drive by 1.5 mm... Sorry Guy's If any problem doing this drop me a e-mail and i will sort Chris