|
#1
|
|||
|
|||
New yz2 chassis bent?
Hi all
Just brought a new YZ2 CA/DT chassis. When I opened the packet and placed it on my glass set up board I noticed it doesn't sit flat. There's a bend in the middle. Checked it again with a straight edge to just confirm. Is this normal? Cheers |
#2
|
||||
|
||||
Quote:
What's important is how cleanly the front bulkhead sits on to the chassis side rails, which in a high speed frontal impact can bend. I've done this, so I know the painful replacement cost. I frontal impact car doesn't drive right, and the top bulkhead wont fit without persuasion. I've known people bend them back, but i wasn't happy with that so replaced mine. If it all goes together easily and straight, then you're good.
__________________
-------------------------------------------------------------------------------------------------------------------
Team Yokomo - YZ-2CAL3 | YZ-2DTM3 | YZ-4SF2 | YZ-2T | YZ-2DTM Worlds | YZ-2DTM x2 | YRX-12 x2 ------------------------------------------------------------------------------------------------------------------- 10electric | Batley Buggy Club | YORCC | RHR | MB Models --------------------------------------------------------------------------------------------------------------- |
|
|