|
#1
|
|||
|
|||
novak bl motor problem.
Just soldered up a novak SS+ to a 17.5t novak bl motor.
Programed the esc and when i pull the throttle the motor wont spin. If i spin the shaft the motor will take off and i can control the speed. But. If i let the motor stop it wont go again till i spin it by hand. What is going on??? |
#2
|
||||
|
||||
Sounds like a sensor problem - could be the sensor lead, or possibly the board.
If the speedo will allow sensorless you could try, or the next best bet would be to change the lead. HTH
__________________
|
|
|