Dex410 diff hoop/gearbox holder

[radugns]

Hi,

I try to find a good quality pic with TD aluminum gearbox holder installed, but nothing
Could please someone take a good frame with the setup? I bought an Exotek rear hoop but it does not fit so well, maybe the original solve the problem.
Thanks
Radu

[micholix]

Hi,

I do only have the TD rear diff loop, on my 410v3, i can give you a pic from it at the evening.

[Adam Skelding]

Have a look here:
http://www.oople.com/forums/showthread.php?t=90385

There's a picture of one installed in my DEX410v3.

[radugns]

Thank you, that is great. I have a problem with the Exotek one, I bought it as a pair with front one, and that consists by having a gap between the edge of the diff case.
I am using you pic to show where
http://i.imgur.com/8pELjP7.jpg

The gap is about 0.8mm...and do not like So the stock would solve the problem, I belive. Because the rear bulkhead (330009) is new...so the problem is from the hoop.

[ekt]

Originally Posted by radugns

Thank you, that is great. I have a problem with the Exotek one, I bought it as a pair with front one, and that consists by having a gap between the edge of the diff case.
I am using you pic to show where
http://i.imgur.com/8pELjP7.jpg

The gap is about 0.8mm...and do not like So the stock would solve the problem, I belive. Because the rear bulkhead (330009) is new...so the problem is from the hoop.

Have you checked that the Exotek hoop was sitting flush with your screws? It could have moved during installation due to the slotted screw openings.

[radugns]

Originally Posted by ekt

Have you checked that the Exotek hoop was sitting flush with your screws? It could have moved during installation due to the slotted screw openings.

I checked, I unscrew a little and keep pressure on it while screwing down.
From what Ive checked, the exotek is a little lower, like the first for 23.5mm lipo with just one holes for battery holder pin.
In the pictures from exotek, the front one has a gap and the rear fits perfect.