|
#1
|
||||
|
||||
DEX 210 turnbuckle set up
Did you use the setup/ length of the turnbucles mentioned in the online manual? 12,5/ 19.5 and 20mm?
|
#2
|
||||
|
||||
Yes, found it a bt upright all round.
|
#3
|
||||
|
||||
I didn't use the figures listed in the manual. I just wound the camber links in so they were about level and then adjusted them when on the car to my desired camber angle.
The toe links I adjusted so they were the same length then set them so I had about 1 degree toe in on the car using a toe gauge.
__________________
Lets Off Road! |
#4
|
||||
|
||||
I just fired mine together somewhere close and then fine tuned them to Adam's Worksop setup sheet.
|
#5
|
||||
|
||||
I have never found manual lengths (any brand) to be right for any setup. I think they are given as a starting point to adjust from once the car is built and before it is first used.
James |
Thread Tools | |
Display Modes | |
|
|