|
||
|
 |
|
||||||||||||||||||
|
#1
16-06-2013
|
||||
|
||||
Tekin problems...
I turn my speedo on no problems the motor I think is clicking very quietly on start up and nothing beeps or makes a tone like before it has not even touched the ground yet since I have had it, worked this morning not now. Tried without sensor cable, any advise would be great thanks
 EDIT: When it has started it does show lights for my thortle going up. 
|
|
#2
16-06-2013
|
||||
|
||||
|
Batteries, erm, voltage cut-off?
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
|
|
#4
16-06-2013
|
||||
|
||||
|
4S Lipo?
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
|
|
#6
16-06-2013
|
||||
|
||||
|
this is an RX8?
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
|
|
#8
16-06-2013
|
|||
|
|||
|
With LED's 1,2,6 and 7 flashing means incorrect motor type selected, but this also could be a poor connection from the speedo to motor. As the motor is making a small clicking noise it could be that you have the motor cables wired incorrectly or a bad solder joint, so re-check all and ensure that cable A on the speedo goes to connection A on the motor and like wise for connections B and C.
|
 |
|
|
Linear Mode
