|
#1
|
||||
|
||||
Team line blue hubs for Lazer ZX-R
I'm trying to build a Kyosho Lazer ZX-R mk2. I have a pair of Team Line blue hubs, but am not sure what is needed to fit them. I think they are supposed to have some flanged bearings. Other than that I'm not sure if any other modification is required to fit on the ZX-R mk2. Any thoughts anyone? What are the bearing sizes?
|
#2
|
||||
|
||||
non flanged think they are 4*8 the inner hole of you have the w-5063 and the outer if you have the w-5061
mvh isobarik |
#3
|
||||
|
||||
4x8mm bearings x2 for each castor block. Also some people have fitted them on the wishbone incorrectly so pay attention as these should angle towards the rear of the car. Hope i make sense.
__________________
www.kamtec.co.uk www.fibre-lyte.co.uk answer-rc.com/uk/en/ Answer UK team driver Designer of the Lazer ZX/ZXR carbon fibre tub chassis Designer of the Lazer ZXRS |
|
|