|
||
|
 |
|
||||||||||||||||||
|
#1
12-04-2015
|
||||
|
||||
Wing Wires - Yokomo
I need to make up some wing wires for a couple of my Yoke's. I was going to order some piano wire but I need to know the diameter of the originals.
Anyone either used piano wire and know what diameter I need to order, or got the ability to measure the diameter of the originals please let me know. cheers Tim
__________________
[LEFT][/LEFT - Atomic Carbon CR2 SE - RB5 - ZX5- YZ10 - Bmax2 runners 
|
|
#2
12-04-2015
|
||||
|
||||
|
The old cats are 1.6mm 16swg so I bet the yokes arn't far off I'll dig out my new one and mesure it up for you tomorrow.
__________________
My feedback feel free to add anything  http://www.oople.com/forums/showthre...863#post861863
|
|
#4
13-04-2015
|
|||
|
|||
|
You know piano wire may rust unless zinc / tin coated and even then once tin / zinc coating breaks down can corrode.
Why not consider using a stainless grade such as 302 or 316 For my Losi xx I used 302 and it wasn't much harder to form than piano wire.
|
|
#5
14-04-2015
|
||||
|
||||
|
Here you go Timmy sorry for the delay
It's 2mm thick tre plastic is .1mm so take that off  I would say 73mm across  And 40mm long 
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863
|
|
#7
15-04-2015
|
||||
|
||||
|
No problem pal
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863
|
 |
|
|
Linear Mode
