|
#1
|
|||
|
|||
RC10 Graphite
the rebuild of my Graphite is coming along , it's not 100% as original as I will be using modern electronics and have used a couple of bits off other cars I have lying around.
I have an old type slipper and wondered if people recommend using a more modern type
__________________
B6 |
#2
|
||||
|
||||
Can't you put a B4 shaft in it or something and use a new slipper? Or am I going mad and heard something totally different
__________________
My feedback feel free to add anything http://www.oople.com/forums/showthre...863#post861863 |
#3
|
|||
|
|||
yes that is what i'm thinking of doing, just wondered if that was the norm or people carried on with the old type slipper
__________________
B6 |
#4
|
||||
|
||||
You will not be able to fit a B4 layshaft in a original Stealth box I believe.
The B4 Layshaft is what early RE-RE worlds kits needed as the shaft was machined too short allowing the back slipper plate to hit the motor plate.The B4 shaft was machined in a different place allowing clearance of the slipper plate. Now included in second batch RE-REs The Worlds RE-RE idler is I believe a different size including different size bearings. Part number WORLDS RE-RE IDLER GEAR= 6569 Part number ORIGINAL STEALTH IDLER=6570 I maybe wrong but contact CML to clarify the above, but I think Im right. The single slipper will more than handle 10.5-9.5 I would not go much below this. I know people running 10 double brushed with lipo with single slipper pad and it handles it no problem. Hope this helps.............. Last edited by xfactor; 07-09-2015 at 07:22 PM. |
#5
|
|||
|
|||
Thanks for the good info,10.5 planned so will continue with old slipper
__________________
B6 |
#6
|
||||
|
||||
That will be ok matey......
|
#7
|
|||
|
|||
__________________
B6 |
#8
|
||||
|
||||
Oooooh YES !!!!!
AWESOME JOB........... |
|
|