Go Back   oOple.com Forums > General > Electrics

Reply
 
Thread Tools Display Modes
  #1  
Old 25-06-2019
lastplace lastplace is offline
Member
 
Join Date: May 2009
Location: Nottingham
Posts: 93
Default Skyrc Toro 160 lost calibration

Hi guys has anyone had any experience with there Skyrc esc lossing it's calibration setting each time it's turned off. If I recalibrate it it will run fine, I can turn off the transmitter . Then turn back on and all still works but if I turn off the esc . Then turn back on it just sits there flashing away looking for a signal from the receiver. I did find put that if I try and recalibrate it when the sanwa Exes X transmitter was set with anti lock set to active it would not complete the calibration process.
__________________
Aim Low Get Home Early
Reply With Quote
  #2  
Old 26-06-2019
pugs's Avatar
pugs pugs is offline
Senior Member
 
Join Date: Jan 2007
Location: durham
Posts: 765
Default

Has the esc ever been hooked up backwards....even just for a split second? Iv seen this fault happen on ones which have been reversed connected, blows the flash memory in the main control ic….long as the esc is powered it will work fine, soon as you disconnect the power it loses the set points
__________________
trader feedback here: http://www.oople.com/forums/showthread.php?t=39759
Reply With Quote
  #3  
Old 26-06-2019
mattr mattr is offline
Mad Member
 
Join Date: Mar 2011
Location: Sweden
Posts: 1,838
Default



Yeah, that does happen.......
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 10:41 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
oOple.com