|
#1
|
|||
|
|||
Mi1v2 - Servo won't fit?
Hi all,
I have been building a mi1v2 and had some great help on this forum last time i was stuck so here I am again, I have just been about to put the servo in but have noticed the arm on the steering bracket catches the top of the servo. The manual is here http://www.racing-cars.com/images/Te...-V2_manual.pdf I am on page 20 and the servo I have is low profile which is this one http://www.modelsport.co.uk/alturn-u...roducts/359810 Hopefully its just something silly I am missing, Thanks |
#2
|
||||
|
||||
Have u a picture showing your setup?
__________________
Trader Feedback: http://www.oople.com/forums/showthread.php?t=75866 |
#3
|
|||
|
|||
Hi,
Yes i have attached some pictures to this message (i think) hopefully that will show you what is catching (on the upper left of the servo) Thanks again |
#4
|
|||
|
|||
Still can't seem to figure this out, I assume all servos are the same size, the low profile ones, this was the one the store sold with the kit.
It just catches by a tiny bit. Thanks |
#5
|
|||
|
|||
Some servos are a little thicker than others. I had the same problem and have bought a thinner servo, only because i needed fo another car also. Only thinner by 1 mm or so.
I have seen others mention that they put a 1mm spacer in the servosaver to lift the arm a little. Not sure exactly where they put it. It was on RcTech.net i read that. |
Thread Tools | |
Display Modes | |
|
|