Go Back   oOple.com Forums > Car Talk > Tamiya

Reply
 
Thread Tools Display Modes
  #1  
Old 07-08-2014
SamJones's Avatar
SamJones SamJones is offline
Member
 
Join Date: Jul 2014
Location: Sidcup, Kent
Posts: 144
Default TA03 Diff in a M05

Hi again,

So I ordered my TA03 diff for my M05 and it arrived yesterday. First off I realised The bearings from my 3Racing one wouldn't fit. So I took the F7 part and a bearing and fitted it to my TA03 diff. It went in fine, but after when I turned the car on it's side the diff outputs slipped out (It had the driveshafts in it and all was assembled) They didn't fall out completely, just slipped a few cm from the diff it's self. I also lost all diff action of course.

Hope you can help. (also, could it be I put it together incorrectly?)
Reply With Quote
  #2  
Old 07-08-2014
sosidge's Avatar
sosidge sosidge is offline
Mad Member
 
Join Date: Jun 2006
Posts: 1,774
Default

It sounds like you need to put something in the outdrive to take out the gap to the driveshaft. Either an o-ring or one of the urethane bushings used in the top of the trf shocks.
Reply With Quote
  #3  
Old 07-08-2014
Essex2Visuvesi Essex2Visuvesi is offline
Member
 
Join Date: Jun 2014
Location: Witham, Essex
Posts: 299
Default

couple of damper o rings should do the job nicely.... or a little bit of fuel line
Reply With Quote
  #4  
Old 07-08-2014
SamJones's Avatar
SamJones SamJones is offline
Member
 
Join Date: Jul 2014
Location: Sidcup, Kent
Posts: 144
Default Thanks so much!

Worked perfectly, and have gained much speed and drive ability from my car. Hopefully a few more on this happy driving!
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:50 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com