|
#1
|
|||
|
|||
Output Horn to use on Savox 1258TG on B6
Hi,
I am just building up a new B6 and wondered which is the nearest servo horn to fit the Savox 1258TG servo from the four provided in the B6 kit, fairly sure they're all pretty tight fits but which should I be (gently) forcing on? :-o thanks |
#2
|
|||
|
|||
25t one . prob marked F. Thats what i used on mine
|
#3
|
|||
|
|||
B6 Savox servo horn
Hi its is the F one but the kit one I got was so tight I could not get it on!
Might have just been me being over cautious but it felt too tight to me! |
#4
|
||||
|
||||
As already mentioned use the F 25t horn
__________________
|
#5
|
|||
|
|||
Many thanks, I will try and squeeze the Futaba horn on
|
#6
|
||||
|
||||
They are a tight fit.
|
#7
|
|||
|
|||
I've just built a B6 and have the exact same servo. I used F and found it easier if you put the blue aluminium spacer on the servo (it will be loose) then push the horn on after, and guide the spacer back on from the bottom. Or just do away with the spacer? Not sure how vital it is. Hope this helps ...
Last edited by losimad; 09-04-2017 at 12:34 AM. |
|
|