|
#1
|
|||
|
|||
X-5 Front brace
Hi all, just got myself an x5, however upon building i have found that i dont have a front brace to fit onto the bulk head. Is actually needed to get the x5 up and running?
|
#2
|
||||
|
||||
No but it helps a lot in keeping the bulkhead from breaking. You can add it later and also get the # OP 031 Screw Set, Caster Block set up as well seen here: http://www.xfactoryrc.com/storexfactory.htm. These parts make the front end much stronger.....
|
#3
|
||||
|
||||
Yeah, it won't effect performance, but it is defo better to have to increase the strngth of the front end.
__________________
Nortech is ACE! |
#4
|
|||
|
|||
i have now came across problem with the rear brace, i cant get it to stay on, once i have tightened everythink up, it still falls off, any ideas?
|
#5
|
||||
|
||||
take a piece of motor wire, cut a piece of the shrink off and put over the end of the hinge pin keeps the rear brace on and is a nice and easy fix
__________________
AC S4-LRP SPHERE TC-KO2123-NOVAK 5.5L B4FT-NOSRAM EVO-KO2123-SPASHETT 10x2 http://s343.photobucket.com/albums/o...-rugby-new.gif |
#6
|
||||
|
||||
use originial xxx rear hinge pins, these have e clipped ends instead, like £2 a pair or something
__________________
Nortech is ACE! |
|
|