|
||
|
 |
|
||||||||||||||||||
|
#1
09-04-2014
|
||||
|
||||
fitting a lipo into hand set
Ok I have a NIMH hand set that takes 8 batteries.(1.5v).the q's is can I directly fit a 3s lipo.or do I need to fit a resistor as the lipo is 11.1v nominal.
__________________
Current rides N slides and flies sponsored by http://www.westernvalleymodels.co.uk/
|
|
#2
09-04-2014
|
||||
|
||||
|
You should be able to fit a 11.1v lipo in it, did it with my 3vc.
What radio is it?
__________________
dragon paints : team tekin : fusion hobbies :SCHUMACHER RACING : Nuclear R/C for all my sticky and slippery stuff - if it needs gluing or lubing, Nuclear RC is the man!
|
|
#3
09-04-2014
|
||||
|
||||
|
8 x 1.5v is 12v anyway, but with NiMh cells the nominal voltage is 1.2v so you are unlikely to get 12v.
I use NiMh cells in my son's tx and it usually reports about 10 -11v . As it is designed to run from AA cells it should happily handle 12v however a 3s lipo will be 12.6v fully charged, 4.2v per cell. Most electronics can deal with a range of supply voltages. What is your reason for wanting lipo? For me, it was not having to worry about recharging between meetings because standard NiMh loose too much charge over time. Newer hybrids (eneloop, good to go, pre charged) got over that. They can go months between charges so I haven't bothered with lipo.
__________________
Team C TC02c - My son breaks it, I fix it.
|
|
#4
09-04-2014
|
||||
|
||||
|
I put a 3s lipo in without any issues. It lasts a lot longer, lighter, easier and quicker to charge if at the track or out and about. I always unplug it when not using the handset just in case.
The lipo was only about £10.
|
|
#6
09-04-2014
|
||||
|
||||
|
no problems in my 3VCS. Just take it out to charge it back up with my normal charger.
when fully charged it says 12.6v, but the voltage drops rapidly (in a few minutes) once it gets close to 10.0v. I tend to re-charge it once it gets under 11.0v anyway. I get around 15hrs of runtime between charges.
__________________
 CML Distribution - Distributors of Quality Radio Control Models & RC Hobby Products
|
|
#7
10-04-2014
|
||||
|
||||
|
thanx for the info guys.just looked at this
http://www.hobbyking.co.uk/hobbyking...ter_pack_.html prob a better choice than over powering my hand set.and look at the price
__________________
Current rides N slides and flies sponsored by http://www.westernvalleymodels.co.uk/
|
|
#8
11-04-2014
|
||||
|
||||
|
I've used one of these http://www.hobbyking.co.uk/hobbyking...dProduct=23814 in my 3VCS since I've had it. Never had a problem and it works out about the same as a set of Duracell AA's for it!
__________________
Dragon Paints
|
 |
|
|
Linear Mode
