Transponder Port on Receiver

[Bigdawgracer]

Hi All,

Can someone remind me which port on the receiver the transponder is normally plugged into?

Thanks!

[tonydevon]

A spare one

Ch3 usually

[Bigdawgracer]

Thanks Tony!

[mark christopher]

Any providing its not steering and throttle channel, all the plus and minus pins are on the same track in the circuit board. Only signal wire varies. I all ways use the B (battery) port.

[beale]

If using the Core Code system ch3 can be switched off on the TX, seen that a lot

[crtpromachine]

The transponders are normally plugged into the battery port on the receiver.

[mark christopher]

Originally Posted by beale

If using the Core Code system ch3 can be switched off on the TX, seen that a lot

Correct as can ko, but it does not disable the positive and negative which powers the pt, they are as I put above all on the same tracks on the circuit board

[Bigdawgracer]

Thanks all!