SupaStox - Hobbywing XERUN-120A-1S-SD Fan?
 

About to build SupaStox 1S Kit to run with XERUN-120A-1S-SD ESC, Novak Ballistic 13.5 (Pulled from buggy and now fitted 13.5 3300Kv stator) Is the Fan needed for 1S Lipo setup? (120A ESC has low forward resistance ~ 3 milliohms)
Don't plan on running Maximum Turbo Boost till I have got the car set up sorted.

Any thoughts ?


Trying a Flysky GT3B wheel tranny as they are good value via fleabay ~£30, with lots of features. ;)

no fan needed, and no turbo allowed under BRCA rules, speedo must be set to blinky, and unless your motor is on the EB list with that stator, that would be ilegal too :)

club racing not BRCA events
 

Clubs can run whatever the members agree to so EB rules don't apply :lol: :p Novak ballistic 13.5 is on the EB as it 'appens
Will start without fan and check temp after race

Yup I know that, hence why I put brca..... you could have saved me the time by stating where you were using it. :p
The motor is on the list but as it has to be as supplied to the brca EB I'm pointing out that your mod may make it illegal for brcac use.