Rear pin-drive to hex
 

I normally run Kyosho, so I've a ton of rear wheels that are hex-drive. Is it possible to convert the pin-drive in the rear of the dex410 to hex-drive?

I have used Kyosho axels and weel-hex on my durango, in the rear suspension:) But i had to drill out the "dog bone" pin to 2,5mm

Just buy some hexes for another car and try those.

I've used some old TC hexes on mine so that my old HB wheels fitted the DEX. The axles needed spacing properly so they didn't bind, but it is more than possible.

With a little modification to plastic hexes you can fit other hex fit wheels.

Ive had yokomo rears on mine, the yokomo hex adapter goes straight on no mods needed. Not sure if it's the same size as a kyosho hex tho, they are the same size as a front hex if that helps