ez run esc
 

im using the ezrun v2 esc wit the turnigy motor but it will go for a bit the will stop with the red and green lights flashing togher when i pull the stick forward does any1 know what causes this help plzzz

isnt there nothing in the manual ant, have you tried doing the setup again via button, set mine up today, goes like sh*t off a shovel, :p

Check what setting your lipo cutoff is on - should be 3v per cell, easier with the programming card if you have one/borrow one as the manual setup isn't the best

esc
 

im sure ive got the lvc turned off it only does it so often it will run then ill stop it then wount move with the green and red flashing at same time making a clicking noise then ill push car an it will go :( very odd

Try dropping a pinion size or two

If i remember right, this is a safety cut off following the loss of signal to the receiver.

Its particularly an issue with Etronix / code setups

Loses signal once, cuts off until you switch off and on. Cannot switch the function off.

Best to email hobbywing just to make sure. They answered my question within 24 hours

Found a site that might help - seems like a similar problem to how you describe, worth a look

http://www.rcknowhow.co.uk/2011/03/e...or-esc-review/

bang on
 

nice one it was the throttle link :P

throttle curve
 

curve i ment lol