I've had this discussion but don't know anyone that would take their heatshrink off their packs so we could try. Have you tred that Stan?
I'm sure Paul designed the X6 chassis around the ROAR rules at the time which I imagine didn't consider saddle pack Lipo (it was like 3 years ago). When I measued 2 saddles, I thought they should fit in by less than 1mm, so if they don't fit you should only have to tickle out the chassis edges with a Dremel.
Ref the speedo I prefer the motor endbell side to cable tie the wires down the side. If you run Spektrum I have my aerial inside the shell, sticking up on a bit of lexan to get some height, a Fastrax 3 quid alu mount for when I ran 40mhz.
__________________
Nortech is ACE!
|