Quote:
Originally Posted by c0sie
Was the guide as easy to follow as it looks?
|
Yes
Quote:
Originally Posted by c0sie
Any issues you came across?
|
Didn't need to ream out ariel hole in tranny case.
Removed bottom section of Spekrum ariel tube, the part that swivels. Top part needs a gentle tug to remove. Then wire and antenna were left in bottom half

. Then removed wire from swivel and pushed antenna back up main tube.
Ariel wire is crimpped into the fitting @ the end of it and is a good push fit onto the board. Had to resolder wire to clip.
Ground away part of the ariel channel in the case for the ariel wire to pass through so as not to trap it.
When put back together the top of the Skektrum areil mast is soft so is crimped in place by the to case halves going together again.
Just need to remove the sleeve on the back of the module now.
I'll see about some pics in a day or two