The bit that sticks out is indeed from the T4 battery strap I used to make, however it gives that extra support so left it on there.
Phil have everything covered above really, I just screwed into the chassis with two short 4/40 screws, it is essential you countersink inot the carbon though to clear the front of the wishbone. There is not really much load on this to be honest, so as long as you don't crank those screws down there is enough support for this, worst case though run some glue round the edge to really toughen it up.
Mills - Firstly, I thought you had given up? Are you back? Nationals? Sounds serious if you're afte a 4wd again or do you still have your old X5?
I really like my 8.5, on 25*76, it's perfect for say York indoor. Probably not enough for outdoors though, plan to run a 7.5L then.
__________________
Nortech is ACE!
|