Hi guys,
Thanks for the advice. I am running the E speed hangers, the track I have been running on is carpet, but I am going to have a play at TORCH tommorrow on astro turf. Tyres were mini pin yellows on the carpet.
Front
silver spring / 30wt oil
yellow minipins
hub spacing forward (spacer behind hub carrier)
no toe in or out
1 degree camber
tie rod outer position on shock mount.( the shock mount with vertical ball studs if that makes any difference) 1 thin washer under ballstud
tie rod outer position on hub.
ride height - axles level
shock mount inner on wishbone, 2nd most inner hole on shock tower
Rear
Silver spring / 30wt oil
1 degree camber
no trans shims
no anti squat shims
shock position middle on wishbone and 2nd most inner on shock tower
middle hub spacing
Plastic hubs, tie rod on the outer most hole. e speed hangers
This is how it was running on Friday, I have just put some weight (30g) ontop of servo, and put the green springs on the rear.
There are 2 reasons I can't run 4+2, one because I share my cells with my tc, and they wouldn't fit. Other reason is I have a smart tray and they won't fit in it.
I think I will just bite the bullet and go lipo. I'm fed up of discharging anyway
Thanks for the helpful advice so far, I didn't realise the X-6 crew were this friendly/helpful!
Cheers
Lloyd
